Author Topic: WTB: OE Hardware - Torsion Cover Bolts  (Read 40 times)

0 Members and 1 Guest are viewing this topic.

Offline Marcel

  • Full Member
  • Posts: 41
  • Country: ca
  • Karma: 0
  • AirSpeed Forum Member
WTB: OE Hardware - Torsion Cover Bolts
« on: February 11, 2019, 11:12:46 AM »
I was re-adjusting the spring plates on my oval project the other day and I noticed that 4 of the bolts for the torsion cover are in pretty bad shape. So... I'm looking for some OE hardware to replace them. I'm not concerned which OE manufacturer they are, just as long as they're original. I need 4 and don't need washers but I will buy a full set if that's how you want to sell. I've ordered a set of new ones from WW but would prefer to use OE if I can get'em.

They are for 1956 Oval Beetle:

37.15mm overall length.
29.74mm measured under the bolt head.
M10 Coarse x1.50mm thread pitch.
8G grade.
17mm bolt head.
7.31mm shoulder under the head.

Thanks!

Joe 
2 Doors & Flat Fours
'56 Beetle
'00 Impreza RS Coupe
'16 Subaru BRZ

 

Powered by EzPortal