Author Topic: Am I asking for trouble?  (Read 647 times)

0 Members and 1 Guest are viewing this topic.

Offline Johanness

  • Full Member
  • Posts: 10
  • Country: ca
  • Karma: 0
Am I asking for trouble?
« on: May 24, 2016, 04:39:48 PM »
Hi all.

I have a wanted ad in the classified section looking for a decent notchback to start my next project.

However doing a bit more research online, am I asking for trouble trying to put some decent hp #'s in this type?  I've seen the following:

Is there any way to mitigate the higher temps I'm imagining is going to be an issue?

Anyone who's been down this road, any advice is appreciated.

(FYI, I came out of a turbo'd injected built 1915 in a 62 bug previous)


Offline Parts

  • Full Member
  • Posts: 71
  • Country: ca
  • Karma: 0
  • AirSpeed Forum Member
Re: Am I asking for trouble?
« Reply #1 on: May 25, 2016, 08:08:36 AM »
Read the feedback on GEX. Then decide.

Offline Russ

  • Full Member
  • Posts: 317
  • Country: 00
  • Karma: 9
Re: Am I asking for trouble?
« Reply #2 on: May 25, 2016, 08:46:06 AM »
I have no experience with notch's but I think if you ran an external oil cooler/fan it would bring the temps down


Powered by EzPortal