Author Topic: 57 VW in need of a qualified welder  (Read 773 times)

0 Members and 1 Guest are viewing this topic.

Offline 57rubindub

  • Full Member
  • Posts: 59
  • Country: ca
  • Karma: 0
  • AirSpeed Forum Member
57 VW in need of a qualified welder
« on: July 01, 2013, 04:56:36 PM »
Ok here's the skinny..
I need to get some fab work done, I have a 57 bug that requires replacing floor pans, rear inner wheel shroud (left/right) heater channels, rear body mount panels and rear driver bumper channel, i'm sure there are a few other things to get done but that is primarily where I will start. I will be supplying all new metal required and the car is/will be ground to bare metal before fab. So my question the vw webasphere is can you recommend a "qualified" shop / person for this work. Im not in a big rush to get the car back from fab but want it done properly. Im not turning this car into a concorse ready show car but I want quality work as I only want to do this once.
Any feedback is appreciated.

 

Powered by EzPortal